Anticoagulant Citrate Phosphate Dextrose (Cpd) And As-5 Red Cell Preservative
FDA Drug Information • Also known as: Imuflex Wb-Rp Blood Bag System With Integral Whole Blood Leukocyte Reduction Filter (Removing...
- Brand Names
- Imuflex Wb-Rp Blood Bag System With Integral Whole Blood Leukocyte Reduction Filter (Removing Platelets) With Diversion Blood Sampling Arm Anticoagulant Citrate Phosphate Dextrose (Cpd) And Optisol (As-5) Red Cell Preservative, Imuflex Wb-Sp Blood Bag System With Integral Whole Blood Leukocyte Reduction Filter (Saving Platelets) With Diversion Blood Sampling Arm Anticoagulant Citrate Phosphate Dextrose (Cpd) And Optisol (As-5) Red Cell Preservative For Collection Of 500Ml Of Blood, Reveos Select Cpd With As-5 Red Cell Preservative Solution For Collection Of 500Ml Of Blood
- Route
- INTRAVENOUS
- Dosage Form
- KIT
- Product Type
- HUMAN PRESCRIPTION DRUG
Description
11. DESCRIPTION / PRODUCT SPECIFICATIONS 11.1. This blood bag system includes a 16 gauge x 1 1/2 inch (1.60 × 38 mm) needle with needle cover and a 500mL (nominal capacity 600mL) collection bag containing 70mL Citrate Phosphate Dextrose (CPD) anticoagulant. The Quadruple blood bag set has one integrally attached empty primary bag, one empty XT-612 5 day Platelet bag, and one satellite bag containing 111 mL OPTISOL Red Cell Preservative Solution. 11.2. Blood bag codes ending in A6 are the collection set with an Integral Diversion Blood Sampling Arm for obtaining donor samples prior to collection of the Whole Blood Unit. 11.3. Blood bag codes ending in A6 also include a DonorCareTM Needle Guard pre-attached to the donor tubing. DonorCare Needle Guard device instructions are provided on the reverse side. 11.4. The blood bag collection set is made of PVC (polyvinyl chloride with DEHP plasticizer). 11.5. The blood bag has no components made of natural rubber latex. 11.6. Tubing internal diameter (ID) nominal 3.0 mm. 11.7. Tubing outer diameter (OD) nominal 4.4 mm. 11.8. Tubing line maximum 16 segments available.
What Is Anticoagulant Citrate Phosphate Dextrose (Cpd) And As-5 Red Cell Preservative Used For?
1. INDICATIONS AND USAGE 1.1. Read these instructions carefully before use. 1.2. Rx ONLY. 1.3. Intended for the collection, processing and preservation of Whole Blood and blood components. Not intended for direct intravenous infusion. 1.4. For the collection of 500 mL ±10% Whole Blood. 1.5. Integral Diversion Blood Sampling Arm is intended to divert and obtain donor samples for laboratory testing prior to collection of the Whole Blood unit. 1.6. Integral filter unit intended for leukocyte reduction of Whole Blood up to 8 hours after blood collection when Whole Blood is stored at ambient temperature. 1.7. For further processing, use standard component processing techniques.
Dosage and Administration
2. DOSAGE AND ADMINISTRATION 2.1. To open blister package, peel cover film back 4/5 of its length. 2.2. Prepare the blood bag following your institution's standard operating procedures. 2.2.1. Materials Needed : Evacuated blood collection tubes (glass or plastic) 2.3. Make a loose knot in the donor tubing below the "Y" and CLIKTIP (inline closure device) unless alternate methods are used to seal the tubing at the end of collection. 2.4. Temporarily clamp donor tubing between the phlebotomy needle and the "Y". 2.5. Suspend the collection bag as far as possible below the donor's arm. 2.6. Apply blood pressure cuff or tourniquet to donor's arm. Disinfect site of phlebotomy. If blood pressure cuff is used, inflate to approximately 60 mmHg. 2.7. Remove the needle cover and perform phlebotomy. Remove the temporary clamp on the donor tubing to permit blood flow into the Diversion Blood Sampling Arm pouch. 2.7.1. CAUTION: Do not touch the needle after removing the needle cover. 2.8. Secure the needle safety device in place following the device instructions provided on the reverse side. 2.9. Secure donor tubing to donor's arm. 2.10. Position the diversion pouch with the notches up and the Tube Holder/Luer Adapter assembly down. When the level of blood in the pouch is approximately in line with the notches, the diversion pouch is full. (Fig. 2a) 2.10.1. NOTE: The approximate fill volume of the pouch at the notches is 35 mL. 2.11. Permanently seal the tubing between the "Y" and the diversion pouch to maintain a closed system using an aluminum clip or a tube sealer approved for use with tubing connected to a donor (Fig. 2b). 2.11.1. CAUTION: Do not use a dielectric tube sealer to seal the tubing while the needle is connected to the donor's body unless it is approved for such a purpose. 2.12. To initiate blood flow into the collection bag, break the CLIKTIP between the "Y" and the collection bag. 2.13. To avoid clot formation, collect samples as soon as possible from the diversion pouch as follows (Fig. 2b). 2.13.1. CAUTION: Do not collect donor test samples until the tubing between the "Y" and the diversion pouch is permanently sealed. 2.13.2. Break the CLIKTIP in the tubing below the pouch to open the pathway for sampling. (Fig. 2b) 2.13.3. Position the diversion pouch with the notches up and the Tube Holder/Luer Adapter assembly downward. Assure that any air in the pouch is at the top and will not enter the blood collection tubes. 2.13.4. Open the Tube Holder lid and insert blood collection tube firmly into the tube holder; when full, remove sample tube from holder. Repeat to collect additional samples. 2.13.5. NOTE: The pouch may be removed after the donor test samples are collected. A second seal must be made between the diversion pouch and the permanent seal prior to removing the pouch. 2.14. Mix blood with anticoagulant in the collection bag and continue to mix at several intervals during collection and immediately after collection. If using an...
Warnings and Precautions
5. WARNINGS AND PRECAUTIONS 5.1. Rx ONLY. 5.2. Do not use unless solutions are clear and free from particulates. 5.3. Always inspect the blood bag set for leaks before use. 5.4. Avoid excessive heat and direct sunlight. Protect from freezing. 5.5. Recommended storage conditions: Room Temperature (15-25°C/59-77°F). 5.6. It is normal to have condensation in the blister packaging. If the amount of moisture is greater than expected, check for leaks from the fluid-filled components of the blood bag set. 5.7. Use aseptic techniques. 5.8. Do not use a dielectric tube sealer to seal the tubing while the needle is connected to the donor's body unless it is approved for such a purpose. 5.9. Do not touch needle after removing the needle cover. 5.10. Do not collect donor test samples until the tubing between the "Y" and the diversion pouch is permanently sealed. 5.11. Discard the Diversion Blood Sampling Arm and phlebotomy needle/donor tubing according to institutional standard operating procedures. 5.12. The AGELESS oxygen absorber packet, (Mitsubishi Gas Chemical) contained in this package absorbs oxygen and generates heat on removal. Do not open and handle it with care. 5.13. Dispose of the AGELESS packet with the blister tray. 5.14. Do not dispose the AGELESS packet with wastes containing volatile or flammable materials. 5.15. Due to possible exposure to infectious agents in the handling of blood, take adequate precautions at all times to prevent exposure to and transmission of such agents. Follow your institution's standard operating procedures.
How Supplied
16. HOW SUPPLIED/STORAGE AND HANDLING 16.1. Single use only. 16.2. Sterile and non-pyrogenic fluid path. Sterilized by steam. Opacity of the blood bag system may be observed. This is due to moisture absorption during the sterilization process. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually. 16.3. A Material Safety Data Sheet (MSDS) is not required for this product. 16.4. Recommended storage conditions: Room Temperature (15-25°C/59-77°F). 16.5. Avoid excessive heat and direct sunlight. Protect from freezing. 16.6. To open blister package, peel cover film back 4/5 of its length. 16.7. After opening, the blood bag system may be stored at room temperature for 7 days, or it may be stored for 30 days in the blister package after returning the cover film to the original position and sealing with tape to prevent possible loss of moisture. 16.8. Blood bags in the unopened blister package may be used through the last day of the month and year as indicated on the original manufacturer's packaging. 16.9. The AGELESS packet contained in this package absorbs oxygen and generates heat on removal. Do not open and handle it with care. 16.10. Dispose of the AGELESS packet with the blister tray. 16.11. Do not dispose the AGELESS packet with wastes containing volatile or flammable materials. 16.12. For the Quadruple blood bag set, Code BB * LGQ506A6 is supplied 15/case. Figure
About This Information
This drug information is sourced from FDA-approved labeling via the openFDA database. It is intended for educational and reference purposes only. This is not medical advice. Always consult your healthcare provider before making decisions about medication. Drug information may be updated by the FDA; check with your pharmacist for the most current information.
What are side effects?
Side effects are unwanted reactions that can occur when taking a medication. They range from mild (headache, nausea) to severe (allergic reactions, organ damage). Not everyone experiences side effects, and severity varies. Report any concerning side effects to your doctor.
What are drug interactions?
Drug interactions occur when a medication is affected by another drug, food, or supplement. Interactions can make medications less effective or cause dangerous side effects. Always tell your doctor about all medications and supplements you take.